Skip to content
ASTERON

Equipment

Standby, prime and continuous: what generator ratings mean

The same generator set carries different ratings for different duties. Understanding them prevents both undersized plants and unnecessary cost.

ASTERON Engineering

Generator set ratings are a frequent source of confusion. Two offers for sets of apparently equal output can describe quite different machines, because the output is quoted for different duties.

Three ratings, one machine

An engine can deliver more power for a short time than it can sustain indefinitely. Manufacturers therefore publish several ratings for the same generator set, each tied to a type of duty. The widely used definitions come from ISO 8528, and manufacturers apply them with their own detailed conditions — so the datasheet for the specific set is always the reference.

Standby rating

The standby rating applies to emergency use: supplying a facility when the normal source fails. It assumes a variable load, a limited number of running hours per year, and no overload capability.

A set specified at its standby rating is appropriate where it runs only during outages. It is not appropriate as the main source of power, however attractive the higher output figure may look.

Prime rating

The prime rating applies where the generator set is the main source of power for a variable load, with no fixed limit on annual running hours. The average load over time is expected to be below the rating, and a limited overload capability is typically available for short periods.

Most off-grid industrial sites — mines, remote plants, construction projects — need prime-rated generation.

Continuous rating

The continuous rating applies to supplying a constant load for unlimited hours, as in baseload operation or running in parallel with a grid at fixed output. It is the lowest of the three figures for a given set, because the engine works at that level without relief.

Site conditions change the answer

Published ratings are stated for reference conditions. High ambient temperature and altitude reduce the power an engine can deliver and the heat a cooling system can reject. A set must therefore be evaluated at the conditions of the site, not at the reference conditions on the datasheet.

Fuel matters too. For gas engines in particular, the achievable rating depends on the composition of the gas.

Choosing the right rating

Start from how the set will actually be used:

  • Running only when the grid fails → standby
  • Main source of power with a varying load → prime
  • Constant output for long hours → continuous

Then check the rating at site conditions, and consider the load profile: a prime-rated plant still needs units sized so they operate in an efficient range most of the time.

Comparing offers on the same rating basis, at the same site conditions, is the first step in comparing them fairly.

Related

Continue exploring

Solution

Diesel Power Plants

Prime, continuous and standby diesel generation engineered as a complete plant — synchronised, protected and ready to connect.

Solution

Gas Power Plants

Gas engine power plants for sites with pipeline gas, LPG or biogas — engineered for long running hours and stable baseload.

Engineering

Equipment Selection

Selecting each component on technical merit for the application — ratings, configuration and options defined by the design.

Start with your load

Tell us about your load. We’ll engineer the system.

Share what you know about your project — even if some of it is still undecided. Our engineers review every inquiry.

No price lists. Every proposal is engineered to your project.